Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Side Mirror Motor
Remove door trim panel. Disconnect mirror motor connector from mirror switch harness. Using 2 jumper wires, connect battery voltage and chassis ground to specified wire terminals. See SIDE MIRROR MOTOR TESTΒ table. Observe mirror for proper movement. If mirror motor fails any portion of test, replace mirror assembly.
| Mirror Movement | Battery Voltage | Ground | |||
|---|---|---|---|---|---|
| Left Mirror | |||||
| Up | BRN | BRN/YEL | |||
| Down | BRN/YEL | BRN | |||
| Left | LT GRN | BRN/YEL | |||
| Right | BRN/YEL | LT GRN | |||
| Right Mirror | |||||
| Up | BRN | BRN/BLK | |||
| Down | BRN/BLK | BRN | |||
| Left | LT GRN/BLK | BRN/BLK | |||
| Right | BRN/BLK | LT GRN/BLK | |||
|
|||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
