Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Ford Explorer 2D Utility, 4WD, StandardFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Fuel Supply Manifold Bolts | 7-10 (10-14) |
| Lower Intake Manifold Bolts | 15-18 (20-24) |
| O2 Sensor | 30 (41) |
| Throttle Body-To-Manifold Bolts | 6-9 (8-12) |
| Upper Intake Manifold Bolts | 15-18 (20-24) |
| INCH Lbs. (N.m) | |
| Camshaft Position Sensor Bolts | 22-31 (2.5-3.5) |
| Crankshaft Position Sensor Bolts | 75-106 (9-12) |
| Fuel Pressure Regulator Bolts | 71-98 (8-11) |
| Fuel Supply Manifold Bolts | 72-84 (8-11) |
| Pressure Relief Valve Cap | 4-6 (.5-.7) |
| Thermostat Housing Bolts | 71-98 (8-11) |
| Throttle Position Sensor Screws | 11-16 (1.2-1.8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.