Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Ford Crown Victoria BaseFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Module | On front of upper radiator support. See Figure . |
| Air Bag Diagnostic Module | Behind right side of dash, above glove box. See Figure . |
| Air Suspension/EVO Steering Module | Below right side of rear package shelf. |
| ATC Control Module | Behind center of dash. See Figure . |
| A/C-Heater Blower Motor Speed Controller | On right side of firewall, on evaporator case. See Figure . |
| Daytime Running Lights (DRL) Module | On front of upper radiator support. See Figure . |
| Ignition Control Module (ICM) | In engine bay, on left rear inner fender panel. See Figure . |
| Illuminated Entry Module | Behind top of right kick panel, behind insulator. See Figure . |
| One Touch Window Down Module | In center of driver's door, near master control switch. |
| Powertrain Control Module (PCM) | Behind left side of dash, on left side of firewall. See Figure . |
| Remote Keyless Entry Module | Behind top of right kick panel, behind insulator. See Figure |
| Speaker Interrupt Module | In trunk area. |
| Warning Chime Module | Behind center of dash, to right of steering column. See Figure . |
| Windshield Wiper Control Module | Behind center of dash, above warning chime module. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
