1994 Ford Aspire SE, StandardFACTORY OEM SERVICE PROCEDURE

Ignition Timing

  1. Set automatic transmission lever to Park position, or manual transmission lever to Neutral position. Start and warm engine to normal operating temperature. Connect timing light. Turn off all accessories.
  2. Connect jumper wire between Self-Test Input (STI) terminal and ground. See Fig 1 . If timing marks on crankshaft pulley and index pointer are not aligned, go to next step. If timing is as specified, no adjustment is required.
  3. Loosen distributor bolts. Rotate distributor until timing marks are aligned. Tighten bolts to 14-18 ft. lbs. (19-25 N.m). Recheck timing. Readjust as necessary. Disconnect jumper wire and timing light.
Fig 1: Identifying Self-Test Input Terminal
G94C44133Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.