SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1994AEROSTAR VAN CARGO EXTENDED, 3.0 U, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONMAINTENANCE REMINDER LIGHT (RESET PROCEDURES)ENGINE OIL REPLACEMENT REMINDERENGINE OIL REPLACEMENT REMINDER RESET - PROCEDURE 07OWNER'S MANUAL 1
1994 Ford Aerostar Van Cargo Extended, 3.0 U, Standard

Owner's Manual 1

1994 Ford Aerostar Van Cargo Extended, 3.0 U, StandardSECTION Owner's Manual 1
NOTE: To reset the oil service light and clear the oil change message after servicing use the following procedure:
  1. Begin with the ignition off.
  2. Turn the key to the accessory position for keyed vehicles and for push button start vehicles press the Start/Stop button once quickly. DO NOT attempt to start the engine.
  3. Press the brake and accelerator pedals at the same time. Hold down fully for at least 20 seconds.
  4. Release both the accelerator and brake pedals.
  5. ENGINE OIL CHANGE DUE NEXT SERVICE and [Wrench & Oil Can icon] will display in the message center.
  6. Rotate the key to the OFF position.
  7. Turn the vehicle off. The message and lights will be cleared.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.