Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Ford Probe Base, StandardFACTORY OEM SERVICE PROCEDURE
ABS Service Code Retrieval
WARNING: This page is about a different car, the 1994 Mercury Tracer, 1994 Ford Probe, and 1994 Ford Escort. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ABS warning light was on (before equipment hookup) in QUICK TESTS QT-3 and QT-4. Turn ignition on. If using Super Star II, turn ignition on, wait 2 seconds then turn tester on. If ABS warning light flashed briefly then went out, system is functioning properly. Check brake system for non-ABS related symptom.
- If light is constantly on, record trouble codes. Erase trouble codes. See CLEARING TROUBLE CODES . Re-attempt trouble retrieval. Record re-created trouble codes. Repair codes as necessary. See Figure . If no codes were re-created, go to QUICK TEST QT-7 .
- If light flashes trouble codes, record codes. Erase trouble codes. See CLEARING TROUBLE CODES . Go to QUICK TEST QT-7 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
