1993 Ford Probe Base, StandardFACTORY OEM SERVICE PROCEDURE

ABS Control Unit Ground Check

WARNING: This page is about a different car, the 1994 Mercury Tracer, 1994 Ford Probe, and 1994 Ford Escort. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Disconnect ABS control unit connector. See COMPONENT LOCATIONSΒ  . Using DVOM, measure resistance between ground and both Black wires at ABS control unit 12-pin connector. If resistance is less than 5 ohms, replace ABS control unit. If resistance is more than 5 ohms, repair open in appropriate Black wire.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.