1993 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

ABS Service Code Retrieval

WARNING: This page is about a different car, the 1994 Mercury Tracer, 1994 Ford Probe, and 1994 Ford Escort. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ABS warning light was on (before equipment hookup) in QUICK TESTS QT-3 and QT-4. Turn ignition on. If using Super Star II, turn ignition on, wait 2 seconds then turn tester on. If ABS warning light flashed briefly then went out, system is functioning properly. Check brake system for non-ABS related symptom.
  2. If light is constantly on, record trouble codes. Erase trouble codes. See CLEARING TROUBLE CODES  . Re-attempt trouble retrieval. Record re-created trouble codes. Repair codes as necessary. See Figure . If no codes were re-created, go to QUICK TEST QT-7  .
  3. If light flashes trouble codes, record codes. Erase trouble codes. See CLEARING TROUBLE CODES  . Go to QUICK TEST QT-7  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.