1993 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Test SML - Switch Monitor Light: Notes

NOTE: Enter this test only when directed here by SWITCH MONITOR TEST. Switch monitor light is located on Super Star II/Super Mecs adapter. This test is intended to diagnose SML circuit only.

1) Check For Open SML Wire  Turn ignition off. Install breakout box, leaving PCM disconnected. Measure resistance between SML test pin (No. 38) at breakout box and SML terminal at data link connector. See Figure. If resistance is less than 5 ohms, go to next step. If resistance is at least 5 ohms, repair open SML wire.

2) Check For Short In SML Wire  Turn ignition off. With breakout box installed and PCM disconnected, measure resistance between ground and SML test pin (No. 38) at breakout box. If resistance is more than 10,000 ohms, replace PCM. If resistance is 10,000 ohms or less, repair short in SML wire.

Fig 1: High Presssure Switch Ckt & Connector Terminal ID Type "A" Switch
G93C39752
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.