1993 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Solenoid Valve (SV) Check At ABS Control Module

  1. Turn ignition off. Disconnect ABS control module. See Figure . Set VOM on 200-ohm scale.
  2. At ABS control module, measure and record resistance between following wires:
    • Yellow /White wire and Yellow/Green wire (Left Front Solenoid).
    • Yellow /White wire and Blue/Orange wire (Right Front Solenoid).
    • Yellow /White wire and Brown wire (Left Rear Solenoid).
    • Yellow /White wire and Black/Green wire (Right Rear Solenoid).
  3. If resistances are about 3 ohms, go to PINPOINT TESTS HSI-1Β  and HSI-2Β  . If resistances are not as specified, go to PINPOINT TEST SV-4Β  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.