1993 Ford Probe Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Motor Operation Check

Ensure hydraulic actuation assembly is disconnected. Verify motor terminal receiving Red/Yellow wire from 2-pin connector. Apply 12 volts to Red/Yellow terminal on motor. Using jumper wire, momentarily ground remaining motor terminal (Black wire). If motor operates, go to PINPOINT TEST MMR-9Β  . If motor does not operate, replace hydraulic actuation assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.