Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test Re: Re9
- Ensure ignition switch is in OFF position. Disconnect control module connector No. 2, right power door key lock switch connector, left power door lock switch connector and CPU connector.
- Check resistance in Yellow/Red wire between control module connector No. 2 and following:
- Right power door key lock switch connector.
- Left power door lock switch connector.
- CPU connector.
If resistance is less than 5 ohms, replace control module. If resistance is at least 5 ohms, repair Yellow/Red wire.
- Check resistance in Yellow/Red wire between control module connector No. 2 and chassis ground. If resistance is greater than 10,000 ohms, replace control module. If resistance is 10,000 ohms or less, repair Yellow/Red wire.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.