Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Ford Explorer 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Pinpoint Test E (Code 223)
- Check SPOUT At ICMÂ Perform PRELIMINARY CHECK listed under EI SYSTEM LOW DATA RATE (2.3L). Turn ignition off. Connect diagnostic cable negative and positive leads to battery. Install diagnostic cable to breakout box and ICM (terminals No. 1-6). Use 2.3L EI overlay. Start engine. Measure voltage between J36 (SPOUT) and J60 (BAT-). If voltage is greater than 2 volts, go to step 2). If voltage is 2 volts or less, go to step 6).
- Check Dual Plug Operation Using a neon bulb spark tester, check for spark at each left side plug wire with engine running. If spark is present at one or more wires during dual plug operation, replace ICM. If spark is not present at one or more wires, go to step 3).
- Check DPI Circuit Continuity Turn ignition off. Remove diagnostic cable from ICM (terminals No. 1-6). Leave cable attached to module tee. Disconnect PCM. Measure resistance between terminal No. 32 (DPI) at PCM wiring harness connector and breakout box J54 (DPI). If resistance is 5 ohms or less, go to step 4). If resistance exceeds 5 ohms, repair open DPI circuit between ICM and PCM.
- Check DPI For Short To Power Turn ignition on. Measure voltage between J54 (DPI) and J60 (BAT-). If voltage is 0.5 volt DC or less, go to step 5). If voltage is greater than 0.5 volt DC, repair DPI circuit short to power.
- Force Dual Plug Command At ICMÂ Turn ignition off. Connect PCM. Connect ICM to diagnostic cable tee (terminals No. 1-6). Connect a test light between J54 (DPI) and J60 (BAT-). DO NOT jumper J54 (DPI) to VPWR+ or B+ (DPI circuit in PCM will be damaged). Start engine. If test light is on, replace PCM. If test light is not on, replace ICM.
- Check PCM Side Of SPOUTÂ Turn ignition off. Remove diagnostic cable from ICM (terminals No. 1-6). Leave cable attached to ICM tee. Set DVOM on AC voltage range. Crank engine while measuring voltage between J36 (SPOUT) and J60 (BAT-). If voltage is greater than 0.1 volt AC, replace ICM. If voltage is 0.1 volt AC or less, go to step 7).
- Check SPOUT Circuit For Short To Power Turn ignition off. Set DVOM on DC voltage range. Disconnect PCM. Turn ignition on. Measure voltage between J36 (SPOUT) and J60 (BAT-). If voltage is greater than 0.5 volt DC, repair SPOUT circuit short to power between ICM and PCM. If voltage is 0.5 volt DC or less, replace PCM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
