1992 Ford Probe LX, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Injector Test

  1. With engine idling or cranking (no start), use stethoscope to listen for consistent, operational sounds (clicking) coming from each injector. If operational sounds are present, go to FUEL INJECTOR LEAKAGE TEST. If operational sounds are not present, remove fuel injector wiring harness connector(s). Using DVOM, check injector resistance. Replace injector if resistance is not within specification. See FUEL INJECTOR RESISTANCEΒ  .
  2. If injector resistance is within specification, connect Fuel Injector Tester/Cleaner (113-00001) to fuel injector wiring harness connector. Start engine. The continuity light should blink, indicating circuit is complete. If light does not blink, check for 12 volts at injector lead. If 12 volts is not present, repair circuit as necessary.
FUEL INJECTOR RESISTANCE

Application Ohms
1.8L & 2.2L Non-Turbo 12-16
2.2L Turbo 11-15
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.