1992 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Circuit Test STI - Self-Test Input: Notes

NOTE: Enter this test only when SUPER STAR II tester displays STO LO, or VOM displays zero volt.
CIRCUIT PIN IDENTIFICATION

Circuit Breakout Box Pin No. ECA Pin Wire Color
1.8L STI 48 1K Green/Yellow
2.2L
A/T STI 48 1I Red/Yellow
M/T STI 48 1K Red/Yellow
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.