1992 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Continuous Memory Codes (Soft Faults)

These codes indicate a fault that may or may not be present at time of testing. These codes are used to diagnose intermittent problems. Continuous Memory Codes are retrieved during KOEO SELF-TEST. Some codes may turn on MIL or CHECK ENGINE light. Corresponding soft trouble code will be retained in ECA memory. If fault does not reoccur within 40 warm-up cycles (80 cycles on some models), ECA will automatically clear code.

Technician may clear service codes from memory. See CLEARING CODESΒ  . Intermittent faults may be caused by a sensor, connector or wiring-related problems. See INTERMITTENTS in TESTS W/O CODES article in the ENGINE PERFORMANCE Section.

CAUTION: Continuous Memory Codes should be recorded when retrieved during KOEO SELF-TEST. These codes may be used to identify intermittent problems that exist after all KOEO and KOER codes have been repaired and a Code 11 or 111 (pass code) has been obtained. Failure to follow this procedure may result in unnecessary testing. Some Continuous Memory Codes faults may not be valid after KOEO and KOER codes are repaired.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.