Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE
Retrieving Codes
Service codes are retrieved from EEC-IV system through self-test connector. Various methods and test equipment may be used to access these codes:
- Analog Volt-Ohmmeter (VOM).
- Scan tester.
- In-Dash Malfunction Indicator Light (MIL) or CHECK ENGINE light.
SELF-TEST CONNECTOR LOCATIONS
| Application | Location |
|---|---|
| Continental & Mark VII | Right Front Fender Apron |
| Cougar & Thunderbird | In Front Of Right Shock Tower |
| Crown Victoria & Grand Marquis | Left Inner Fender, Above Wheelwell |
| Escort 1.9L & Tracer 1.9L | Right Rear Of Engine, Near Cowl |
| Town Car | Left Firewall, On Wiper Cover |
| Mustang | Left Shock Tower, Near Ignition Coil |
| Probe 3.0L | Left Rear Of Engine Compartment |
| Sable & Taurus | Right Rear Of Engine, Below Map Sensor |
| Tempo & Topaz | Right Rear Of Engine Compartment, Near Cowl |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.