Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Steering Column: Description
Tilt-wheel column is standard equipment.
CAUTION:
On models with Supplemental Restraint System (SRS), observe the following precautions. The air bag system is powered directly from the battery and back-up power supply. Before any repairs are performed, disconnect and shield battery ground cable. Disconnect the back-up power supply BEFORE servicing ANY air bag component. Use caution when working near steering column. Air bag could accidentally deploy at any time.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
