Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Injector Circuit
- Disconnect all injector harness connectors. Using digital ohmmeter, check resistance across terminals of each injector. See appropriate injector resistance table.
- On models without Sequential Electronic Fuel Injection (SEFI), disconnect injector bank harness connector, check resistance of injector bank. See INJECTOR BANK RESISTANCE table. Injectors on SEFI models have each individual injector wired to the ECA. Repair wiring or replace any injector circuit not within specification.
INDIVIDUAL INJECTOR RESISTANCE (1)
| Engine | Ohms | ||
|---|---|---|---|
| Taurus 3.0L SHO | 15.0-18.0 | ||
| All Others | 13.0-16.0 | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.