1991 Ford Probe V6-182 3.0LFACTORY OEM SERVICE PROCEDURE

Transmission Control Systems: Adjustments

LINE PRESSURE

1. Remove the splash shield next to the left front tire.


Line Pressure.:

Factory service manual diagram




2. Remove the square head plug (marked "L") and install Transmission Test Adapter D87C-77000-A and Pressure Gauge T57L-77820-A or equivalent.

Factory service manual diagram




3. Turn the kickdown cable locknuts to the furthest point from the throttle cam (loosen the cable all the way).
4. Shift the transaxle into PARK and warm up the engine.

NOTE: The idle speed should be 700-800 rpm.

5. Turn the locknuts toward the throttle cam until the line pressure begins to exceed 450 kPa (63-66 psi).

Factory service manual diagram




6. Turn the locknuts away from the throttle cam until the specified line pressure is reached.
7. Tighten the locknuts.
8. Turn off the engine.
9. Install the square head plug and tighten to 5-10 N-m (43-87 lb-in).
10. When installing a new kickdown cable, fully open the throttle valve, then crimp the pin with the protector installed as shown. Remove the protector.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.