Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Ford Probe V6-182 3.0LFACTORY OEM SERVICE PROCEDURE
Ignition Diagnostic Monitor (IDM) Operation
The Ignition Diagnostic Monitor (IDM), an output from the ignition module, provides diagnostic information about the ignition system and drives the vehicles tachometer. The Electronic Control Assembly (ECA) receives the IDM signal and compares it to the Profile Ignition Pickup (PIP) sensor signal.
If for some reason the IDM signal is interrupted, a continuous code is registered in the ECA memory. The stored code indicates, that during recent engine operation the ECA received a PIP signal without receiving corresponding IDM input.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
