Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Ford Probe V6-182 3.0LFACTORY OEM SERVICE PROCEDURE
Data Link Connector: Locations
Behind Instrument Panel:
4EAT CONTROL MODULE
BLOWER MOTOR
BRAKE FLUID LAMP CHECKER/IGNITION KEY REMINDER SWITCH
CLUTCH ENGAGE SWITCH
CLUTCH INTERLOCK SWITCH
COLD ENGINE LOCKOUT (CELO)
ELECTRONIC ENGINE CONTROL MODULE (ECA)
FUEL PUMP RELAY
HORN/TURN SIGNAL CANCEL SWITCH
IGNITION SWITCH
INSTRUMENT CLUSTER
INTERIOR FUSE PANEL
INTERNAL RELAY BOX
INTERVAL WIPER MODULE
JOINT BOX
OIL LEVEL MODULE
REAR WINDOW DEFROSTER RELAY
SPEED CONTROL MODULE
STEERING ANGLE SENSOR
STI TEST CONNECTOR
STO TEST CONNECTOR
STOP AND TAIL LIGHT CHECKER
STOP LAMP SWITCH
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
