Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Ford Probe V6-182 3.0LFACTORY OEM SERVICE PROCEDURE
Control Assembly: Service and Repair
1. Disconnect battery ground cable.
2. Remove bezel cover from control assembly face, then the four attaching screws from control assembly housing.
3. Remove passenger and driver sound insulator panels, then disconnect REC/FRESH control cable from selector door assembly.
4. Disconnect blower switch electrical connector and control assembly illumination electrical connector. Remove temperature control cable from temperature blend door assembly at right side of heater case.
5. Remove control assembly and control cables as an assembly. Note the routing of cables for proper installation.
6. Reverse procedure to install.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
