Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
De-4 Relay Diode Check At Abs Control Unit
Ensure ignition is off. Disconnect ABS control unit. Set ohmmeter to 200-ohm scale. Measure resistance between ABS control unit Blue/Orange wire (+) and relay Black wire (-). Reverse leads. If resistance increases when leads are changed, go to DE-6 VOLTAGE AT ABS CONTROL UNIT TERMINAL "B" . If no change, go to DE-5 RELAY DIODE CHECK AT RELAY .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.