Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1991PROBE GL, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMPINPOINT TESTSBRL-2 CHECK SENSOR INSTALLATION
1991 Ford Probe GL, Standard
BRL-2 Check Sensor Installation
1991 Ford Probe GL, StandardSECTION BRL-2 Check Sensor Installation
Ensure sensor is torqued to 12-17 ft. lb. (16-23 N.m). Ensure sensor to rotor clearance is .012-.043" (0.3-1.1 mm). Service as required. Check for intermittent problem from sensor to ABS control unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.