Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE
Test Equipment
The following equipment is recommended to diagnose and test the EEC system. DO NOTΒ attempt to test this system without proper equipment. Damage to vehicle components may result if improper equipment is used.
- The Self-Test Automatic Read-Out (SUPER STAR II) diagnostic tester is recommended but not required. It is specially built for EEC systems and is used to display the 2-digit (numeric) codes programmed into control module. Aftermarket "Scan" tools are also available.
- Analog Volt-Ohmmeter (VOM) with 0-20V DC range can be used, as an alternative to diagnostic tester, to read codes.
- Digital Volt-Ohmmeter (DVOM) with minimum 10-megohm input impedance.
- A breakout box is required to perform certain tests on system. The test pin No. mentioned in CIRCUIT TESTS refers to test pin numbers on breakout box. Once the breakout box has been installed during a test sequence, it may remain connected for the remainder of that test, unless stated otherwise. Aftermarket breakout boxes are also available.
- Vacuum gauge with 0-30 in. Hg range and resolution (units on scale) of 1 in. Hg.
- Tachometer with 0-6000 RPM range, +/- 40 RPM accuracy, and a resolution of 20 RPM
- Vacuum pump with 0-30 in. Hg range
- Timing light
- Spark Tester (D81P-6666-A or ST-125) is required. A modified side electrode spark plug IS NOT sufficient for these testing procedures.
- Fuel Injection Pressure Gauge (T80L-9974-A)
- 12-volt test light (non-powered type)
- Jumper wire about 15" long
NOTE:
In the following tests, circuits and illustrations are provided by Ford Motor Co. Complete EEC system wiring diagrams may be found in WIRING DIAGRAMS
article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
