1991 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE

P-1 Check For Short

Ensure ignition is off. Disconnect battery, ABS control unit and hydraulic control unit. Set ohmmeter to 200-k/ohm scale.

  1. Measure resistance between hydraulic control unit Yellow/White wire and ABS control unit Black/Green wire, and between Black and Blue/Orange wires. Resistance should be greater than 10 k/ohms.
  2. Measure resistance between hydraulic control unit Yellow/Red wire and ABS control unit Black/Green wire, and between Black and Blue/Orange wires. Resistance should be greater than 10 k/ohms.
  3. Measure resistance between hydraulic control unit Yellow/Green wire and ABS control unit Black/Green wire, and between Black and Blue/Orange wires. Resistance should be greater than 10 k/ohms.
  4. Measure resistance between hydraulic control unit Blue wire and ABS control unit Black/Green wire, and between Black and Blue/Orange wires. Resistance should be greater than 10 k/ohms.
  5. Measure resistance between hydraulic control unit Black/White wire and ABS control unit Black/Green wire, and between Black and Blue/Orange. Resistance should be greater than 10 k/ohms.
  6. Measure resistance between hydraulic control unit Brown wire and ABS control unit Black/Green wire, and between Black and Blue/Orange wires. Resistance should be greater than 10 k/ohms. If resistance readings are correct, reconnect battery and go to P-2 CHECK FOR SHORT TO POWERΒ  . If resistance is not correct, repair wire(s) in question.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.