1991 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Hydraulic Control Unit

The hydraulic control unit contains a high pressure gas actuator assembly, an electric pump to provide pressure to hydraulic system for ABS operation, solenoid and cut-off valves to modulate brake hydraulic pressure at each wheel, a pressure switch, proportioning valve and fluid reservoir. The internal electric pump supplies pressure for ABS system to reapply or increase hydraulic pressure as required for maximum braking without wheel lock-up. See Fig 1 .

Fig 1: Cross-Sectional View of ABS Hydraulic Control Unit
G106752Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.