Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test 4, Check Pip Continuity To EEC
Turn key off. Ensure ECA is disconnected. Set DVOM to 2-k/ohm scale. Measure resistance between breakout box pin No. J43 (PIP E) and vehicle harness connector pin No. 56 (PIP). See Figure.
If resistance is less than 5 ohms, go to next test. If resistance is greater than 5 ohms, repair open circuit. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and run QUICK TEST. See TESTS W/CODES article in the ENGINE PERFORMANCE Section.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
