1991 Ford Explorer 2D Utility, RWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Test 31, Check VRS For Open Circuit

With key off and ECA disconnected, set DVOM to 20-k/ohm scale. Measure resistance between breakout box pins No. J32 (VRS S) and J48 (VRS E).

If resistance is less than 2025 ohms, replace VR sensor. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes. If resistance is greater than 2025 ohms, repair open circuit. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes.

NOTE: Tests 32-37 may also be used for diagnosing KOEO Code 16, Continuous Memory Code 18 and/or "CHECK ENGINE" light on: IDM failure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.