1991 Ford Bronco 4.9 Y, Standard, M5OD-R2FACTORY OEM SERVICE PROCEDURE

Test 10, Check Pip Circuit For Short To Power

With key off and ECA disconnected, set DVOM to 2-k/ohm scale. Measure resistance between breakout box pins No. J43 (PIP E) and J1 (BAT +). If resistance is less than 5 ohms, PIP is shorted in harness. Check connectors, and repair or replace harness. Check for fault codes. If resistance is greater than 5 ohms, replace ECA. Clear Continuous Memory, and check for fault codes.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.