Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Quick Test Procedures: Description
The Quick Test diagnostic procedures are functional tests of the EEC-IV system. They consist of 7 basic test steps. These basic steps must be carefully followed in sequence, otherwise misdiagnosis, or replacement of non-faulty components may result.
- Visual Check & Vehicle Preparation. See BASIC TESTING article in this section.
- Check equipment Hook-Up.
- Key On Engine Off (KOEO) Self-Test.
- Computed Timing Check.
- Key On Engine Running (KOER) Self-Test.
- Continuous Monitor Mode (Wiggle Test).
- Intermittents & Diagnosis By Symptom. For more information, refer to H - "Engine Type" TESTS W/O CODES article.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.