Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Quick Test Procedures: Description
The Quick Test diagnostic procedures are functional tests of the EEC-IV system. They consist of 7 basic test steps. These basic steps must be carefully followed in sequence, otherwise misdiagnosis, or replacement of non-faulty components may result.
- Visual Check & Vehicle Preparation. See BASIC TESTING article in this section.
- Equipment Hook-Up
- Key On Engine Off (KOEO) Self-Test
- Computed Timing Check
- Key On Engine Running (KOER) Self-Test
- Continuous Monitor Mode (Wiggle Test)
- Intermittents & Diagnosis By Symptom. For more information, refer to the H - "Engine Type" TESTS W/O CODES article.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.