Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Booster-To-Firewall Nuts | 12-22 (16-30) |
| Brake Line Fittings | 10-18 (14-24) |
| Master Cylinder Fittings | 10-18 (14-24) |
| Hydraulic Control Unit Nuts | 12-18 (16-24) |
| Master Cylinder-To-Booster Nut | 13-25 (18-34) |
| Wheel Lug Nut | 85-105 (115-142) |
| INCH Lbs. (N.m) | |
| Electronic Control Unit Screws | 15-20 (1.7-2.3) |
| Wheel Sensor Bolt And Screw | 40-60 (4.5-6.8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.