1990 Ford Probe V6-182 3.0LFACTORY OEM SERVICE PROCEDURE

Vehicle Speed Sensor: Service and Repair

1. Disconnect battery ground cable.
2. On models with electronic instrument cluster, disconnect electrical connector from sensor.
3. Remove sensor attaching bolt from transaxle housing.
4. Pull sensor from transaxle housing.
5. On models with analog instrument cluster, remove cluster and lens assembly.
6. Remove attaching screws, then the speedometer subassembly.
7. Remove speed sensor.
8. On all models, reverse procedure to install.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.