1990 Ford Probe V6-182 3.0LFACTORY OEM SERVICE PROCEDURE

Data Link Connector: Locations

FUEL INJECTORS: The fuel injectors are mounted in the lower intake manifold.

FUEL PRESSURE REGULATOR: The fuel pressure regulator is attached to the fuel supply manifold.

FUEL FILTER: RH fender apron in the engine compartment.

FUEL PUMP: The fuel pump is mounted on the fuel sender assembly inside of the fuel tank.


Inertia Switch:

Factory service manual diagram




INERTIA SWITCH: The inertia switch is located behind LH interior liftgate area trim panel.

VIP SELF-TEST CONNECTOR: RH side of dash, near wiper motor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.