Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
KOEO Wiggle Test Procedure
Connect test equipment. Turn ignition on and activate self-test with jumper lead or diagnostic tester. Wait 10 seconds, deactivate and then reactivate self-test. Wiggle test mode has been achieved. Tap, move and wiggle the suspected sensor and/or harness area. If a fault is detected, a code may be stored in memory and indicated at the diagnostic tester or Scan tool. Record code and perform CIRCUIT TEST indicated in CONTINUOUS MEMORY CODES chart. See TESTS W/CODES article.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.