1990 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Clearing Codes

To clear trouble codes, run the KOEO SELF-TEST. Deactivate the Self-Test by disconnecting the jumper wire from the STI connector. Disconnect the negative (-) battery cable and depress the brake pedal for 5-10 seconds. The STI connector is located at the left rear of the engine compartment.

SELF-TEST CONNECTOR LOCATION

Application Location
Probe 4-Cylinder Engine Compartment Near Left Strut Tower
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.