1990 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Vacuum Control Valve (VCV)

  1. 2-port valves may be in open or closed position when engine is cold. 2-port valves should reverse when engine is warmed to operating temperature.
  2. For 3-port valves, with a cold engine, passage "A" to "B" should be closed and passage "A" to "C" should be open. See Fig 1 . With engine at normal operating temperature, the VCV should be open between "A" and "B" and closed between "A" and "C".
  3. For the 4-port valve, check "A1" to "B1" and "A2" to "B2" separately. See Fig 1 . 4-port valves may be in open or closed position when engine is cold. 4-port valves should reverse when engine is warmed to operating temperature. If these conditions are not met, replace the valve.
Fig 1: Vacuum Control Valves
G90B14333Courtesy of FORD MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.