Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump Relay
Remove relay (located near heater duct under carpet). Apply 12 volts to terminals "A" and "B". Measure voltage at terminal "E", while individually grounding terminals "C" and "D". See Fig 1 . Ensure voltage is correct. See FUEL PUMP RELAY SPECIFICATIONSΒ table. If voltage is not correct, replace relay.
| Terminal "C" | Terminal "D" | Terminal "E" |
|---|---|---|
| Open | Grounded | Zero Volts |
| Open | Open | 10-14 Volts |
| Grounded | Open | 10-14 Volts |
| Grounded | Grounded | 10-14 Volts |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
