1990 Ford Cutaway 7.3 MFACTORY OEM SERVICE PROCEDURE

Differential Fluid Capacities

AXLE CAPACITIES

Application Quantity
8.8" Ford (1) (2) 5.5 pts. (2.6L)
9.75" Dana M60-1U 6.3 pts. (3.0L)
10.5" Dana M70-2U 6.6 pts. (3.1L)
(1) Conventional & Traction-Lok.
(2) Add 4 oz. Friction Modifier to Traction-Lok Axles.
AXLE CAPACITIES

Application Quantity
Front
Dana 44-IFS L.D. 3.6 pts. (1.7L)
Dana 50-IFS H.D. 3.8 pts. (1.8L)
Dana 60 Monobeam 5.8 pts. (2.8L)
Rear
8.8" Ford 5.5 pts. (2.6L)
10.25" Ford (1) 7.5 pts. (3.5L)
11.25" Dana 80 8.3 pts. (3.9L)
(1) Conventional & Traction-Lok, Semi and Full Float.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.