1990 Ford Bronco II RWD, Standard, M5OD-R1FACTORY OEM SERVICE PROCEDURE

Section 1 (Engine Controls - Specifications): Capacities

WARNING: This page is about a different car, the 1990 Ford Aerostar. However, it is still accessible from the selected car via links, so may be relevant.
BATTERY SPECIFICATIONS

Application & Group Amp Hr. Rating
Standard BXT-65 650
Optional BXT-65 850
COOLING SYSTEM CAPACITIES

Application Quantity
3.0L 11.8 qts. (11.1L)
4.0L 12.6 qts. (11.9L)
CRANKCASE CAPACITIES

Application (1) Quantity
Aerostar 5.0 qts. (4.7L)
(1) Add 1/2 qt. if equipped with oil cooler.
TRANSMISSION CAPACITIES

Application Specification Quantity
5-Speed Overdrive (Mazda R-1) Mercon 5.6 pts. (2.65L)
A4LD Automatic Mercon 9.7 qts. (9.2L)
E4WD Automatic Mercon 10.0 qts. (9.5L)
AXLE CAPACITIES

Application Quantity
7.5" Ford (1) (2) 3.5 pts. (1.7L)
8.8" Ford (1) (2) 5.3 pts. (5.0L)
7.125" Dana 2.5 pts. (1.2L)
(1) Conventional and Traction-Lok.
(2) Add 4 oz. Friction Modifier for Traction-Lok Drive Axles.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.