Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Step 5.0 Perform Engine Running (KOER) Self-Test: Begin
Deactivate Self-Test. Start engine and idle until vehicle is at operating temperature. Run engine for 2 more minutes at 2000 RPM to warm-up EGO sensor. Turn engine off and wait 10 seconds. Activate Self-Test (same as before). Start engine.
Record all service codes displayed. Watch for the Engine Identification codes (ID codes), because a response to the ID code is required for some vehicles:
- If vehicle is equipped with a Brake On/Off (BOO) switch, the brake pedal MUST be depressed and released 1-2 seconds AFTER the ID code is displayed. This tests the ability of the EEC -IV system to detect a change of state in the BOO.
- If vehicle is equipped with Power Steering Pressure Switch (PSPS), the steering wheel MUST be turned at least one-half turn and released within 1-2 seconds AFTER the ID code is displayed. This tests the ability of the EEC-IV system to detect a change of state in the PSPS.
- If vehicle is equipped with E4OD transmission, the Overdrive Cancel Switch (OCS) MUST be cycled 1-2 seconds after the ID code is displayed. This tests the ability of the EEC-IV system to detect a change of state in the OCS.
Next, watch for a possible Dynamic Response Code. The signal is a single pulse or 10 code on the STAR Tester. If it occurs, perform a brief Wide-Open Throttle (WOT).
Is a PASS Code "11" received during the Engine Running Self-Test?
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
