1990 Ford Bronco II 4WD, Standard, M5OD-R1FACTORY OEM SERVICE PROCEDURE

Test H: Step 11

11) Code 41 or 91: Fuel Control Always Lean  If vehicle is equipped with dual HEGOs, Code 41 refers to the Right (rear) HEGO and Code 91 refers to the Left (front) HEGO. Run engine at 2000 RPM for 2 minutes. Turn key off and wait 10 seconds. Rerun KOER Self-Test. Check for Code 41 or 91. If Code 41 or 91 is not displayed, go to step 20). If Code 41 or 91 is displayed, go to appropriate step number as listed below.

  • Engines equipped with MAP sensors: Go to next step.
  • Engines equipped with MA meters: Go to step 14).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.