Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test N: Step 13
13) Check CID Harness For Continuity With key off and breakout box installed, disconnect ECA. Disconnect DIS module. Set DVOM on 200-ohm scale. Measure resistance between Test Pin No. 24 at the breakout box and pin No. 2 (CID signal) at the DIS module connector. If resistance is less than 5 ohms, go to next step. If resistance is greater than 5 ohms, repair open circuit, remove breakout box, reconnect all components and rerun QUICK TEST.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
