1989 Ford Tempo BaseFACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

CIRCUIT PROTECTION DEVICES LOCATION

Component Location
Circuit Breaker
Power Window/Door Lock/Seat In cavity No. 12 of fuse block. See Figure .
Windshield Wiper In cavity No. 2 of fuse block. See Figure .
Fuse Block
Location of Fuse Block Under dash, left of steering column. See Figure .
View of Fuse Block Under dash, left of steering column. See Figure .
Fusible Links
Charging System (Green) D At starter relay. See Figure .
Cooling Fan (Blue) G On left front strut tower.
Cooling Fan (Brown) J At starter relay. See Figure .
Cooling Fan (Green) R At starter relay. See Figure .
ECA (Blue) P In harness, left of master cylinder.
ECA (Blue) S In harness, left of master cylinder.
Ignition Switch (Black) B On left front strut tower.
Lights (Black) A On left front strut tower.
Passive Restraint (Blue) F At starter relay.
Passive Restraint (Blue) H On left front strut tower.
Rear Defroster (Brown) E On left front strut tower.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.