Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE
Normally Closed Valve
- With engine at normal operating temperature, parking brake applied and transmission in Park or Neutral, disconnect air supply line at valve outlet. Remove vacuum line and ensure that a vacuum signal is present at nipple.
- Remove any delay valves or restrictors in line. Vacuum must be present at nipple before proceeding. With engine speed at 1500 RPM and vacuum line connected to nipple, air pump supply air should be heard and felt at outlet.
- With engine at 1500 RPM, disconnect vacuum line. Air at outlet should be significantly decreased or shut-off. Air pump supply air should be heard or felt at silencer ports.
- If valve fails any test and air pump is operating properly, replace valve. Reconnect all vacuum lines.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
