1989 Ford Probe GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Single Window Switch (All Other Models)

  1. Remove switch from vehicle. Test with a self-powered test light or ohmmeter. With switch in "NEUTRAL" position, continuity should be present between terminals No. 1 and 3, No. 2 and 5, and No. 4 and 6. See Figure .
  2. With the switch pushed downward, continuity should be present between terminals No. 2, 4 and 5, and No. 1 and 3. Terminal No. 6 should be disconnected from any other terminal.
  3. With switch pushed upward, continuity should be present between terminals No. 2, 3 and 5, and No. 4 and 6. Terminal No. 1 should be disconnected from any other terminal. If switch does not test as stated, replace switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.