Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Ford Bronco II RWD, Standard, M5OD-R1FACTORY OEM SERVICE PROCEDURE
Alignment Specifications: AEROSTAR
WHEEL ALIGNMENT SPECIFICATIONS (AEROSTAR)
| Application | Specification | ||
|---|---|---|---|
| Ride Height in Inches | N/A | ||
| Adjustment Procedures | 1 | ||
| Camber in Degrees (Fraction) | -3/10 to 2/10 | ||
| Camber in Degrees (Decimal) | -0.3 to 0.2 | ||
| Caster in Degrees (Fraction) | 4 | ||
| Caster in Degrees (Decimal) | 4.0 | ||
| Toe-In in Inches (Fraction) | 1/32 to 5/32 | ||
| Toe-In in Inches (Decimal) | 0.09 to 0.15 | ||
| Toe-In in Degrees (Fraction) | 3/16 to 5/16 | ||
| Toe-In in Degrees (Decimal) | 0.18 to 0.31 | ||
| Toe-Out on Turns (Inner) | (1) | ||
| Toe-Out on Turns (Outer) | (1) | ||
| Steering Axis Inclination (SAI) | (1) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
