1989 Ford Bronco II 4WD, AutomaticFACTORY OEM SERVICE PROCEDURE

Electronic DISTRIBUTORLESS Ignition System (EDIS) Module

  1. Remove EDIS module connector. Measure resistance between module terminal No. 4 (IGND) and No. 9 (GND). See EDIS MODULE PIN IDENTIFICATIONΒ  table. If resistance is less than 5 ohms go to Step 2). If resistance is more than 5 ohms, replace EDIS module and check for fault codes. See appropriate TESTS W/CODES article in the ENGINE PERFORMANCE section.
  2. With key off, check resistance between EDIS module harness connector terminal No. 4 and ECA connector pin No. 16 (IGN GND) of the ECA connector. See Figure. If resistance is less than 5 ohms, replace EDIS module and rerun test. If reading is more than 5 ohms, service open circuit, reconnect ECA and check for fault codes. See appropriate TESTS W/CODES article in the ENGINE PERFORMANCE section.
EDIS MODULE PIN IDENTIFICATION (1)

Pin No. Circuit
1 PIP
2 IDM
3 SAW
4 IGND
5 VRS -
6 VRS +
7 VRS Shield -
8 VBAT
9 GND
10 Coil 1
11 Coil 2
12 Coil 3
(1) When facing module from left to right.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.